Booster Sterlingpower / Battery to Battery Charger 12V 60A

Booster Sterlingpower 120A

IUoUo(4 STAGE) CHARGING

After the simple installation, you are ready to go. As soon as the voltage of the primary battery exceeds 13V (an indication that it is being charged by a charger,
an alternator/light coil or other), the charging process of the connected additional battery/bank begins. If sufficient
charging power is available at the primary battery, the BzB charger charges the new battery/bank with up to 20A. The charging process is optimised using temperature-compensated IUoUo (4-stage) charging technology.
The most effective equalisation charging time is calculated automatically by the software. Four different battery types can be set (AGM, gel, acid closed, acid open). It goes without saying that the device is optimised for our AGM batteries.

Automatic activation

The B2B charger does not need to be activated. It activates automatically as soon as the voltage of the primary battery rises above 13V.
If the voltage drops below 13V and remains there, the B2B charger switches itself off again. It can also be switched on and off manually using the remote control

Guaranteed safety

In addition to safety functions such as undervoltage and overvoltage protection and switch-off if the device temperature is too high, the B2B charger also offers absolute safety,
that the starter battery will not be discharged. As soon as the voltage on this battery falls below a value of 13V, charging is stopped.
During charging, the B2B charger switches to standby mode for three minutes approximately every 20 minutes to allow the starter battery to charge
.

Simple installation

Installation could hardly be simpler, as the existing system does not need to be changed.
Therefore, the B2B charger is simply installed between the existing primary battery (12V) (positive terminal) - usually a
starter battery - and the additional battery/bank (12V or 24V) (positive terminal). Of course, a cable must also be laid on the negative side.

Remote control

A remote control with display can be connected as an optional accessory. This shows all the important data, such as input and output voltage,
charging power, battery and housing temperature, device settings and the current charging level.