- New
SolarEnergyStorageSet 1Phase - 5kVA, 15.4kWh, 5.8kWp
ESS-1P-Set-5kVA15S
SolarEnergyStorageSet 1Phase - 5kVA, 15.4kWh, 5.8kWp
- 1 inverter/charger/solar combi with 5kVA / 5.5kVA peak & 5.8kWp solar controller
- 1 BYD LVL 15.4kWh storage battery
- 3-phase grid meter (phase compensation)
- DC cable and DC fuse, (AC integration must be carried out by an electrician)
- System diagram, configuration via VRM, support for installation
EnergyStorageSet 1-phase - 5kVA, 15.4kWh with MPPT solar controller 250/100
This 1-phase solar energy storage set is able to cover 80 - 90% of the energy requirements of a small family home.
Please note that energy consumption is very individual and is also regarded as such. It is therefore almost impossible to make a definitive statement.
Of course, a corresponding solar system is also necessary. This can be customised, as Victron supports various types of integration. A DC-coupled solar system is most efficient for single-family homes where the greatest energy demand usually occurs in the morning and evening. This set also includes an MPPT solar controller up to 5.8kWp output. Everything integrated and connection ready.
Please note that the string voltage of 250VDC must not be exceeded under any circumstances!
This set can also be combined with a balcony solar system via 230V AC.
The yield naturally varies depending on the location. In the Zurich Oberland z.B. between March and September you can expect approx. 3x the installed peak output per day, on a monthly average. From April with 4+ times the output until mid-August.
Example: 1000Wp installed capacity results in an average daily yield of 3000 - 4000Wh per day spread over the month.
With a 1-phase storage system, the focus is on optimising self-consumption and not on 100%igen stand-alone capability.
This means that in the event of a power failure, only one phase continues to be supplied with power and not all 3 phases as with a 3-phase system.
If no 3-phase loads (heat pump) need to be operated during a power failure, this can usually be solved by adapting the sub-distribution board so that defined loads can continue to be operated even in a power failure scenario. With phase compensation, the other 2 phases can be supported / compensated with up to 3kW during grid operation. Switching takes place without interruption.
The big advantage here is the smaller battery bank and the use of a single inverter/charger.
This also massively reduces the space required.
This system can easily be expanded with additional BYD LVL storage batteries.
The system can also be extended to a 3-phase system and can therefore fulfil most requirements.
The set consists of the following components:
- 1x MultiPlus-II 48/5000/70-50 MPPT 250/100 GX
- 1x BYD LVL 15.4kWh with BMU & cable
- 1x energy meter incl. USB connection cable
- 1x main switch and DC fuse
- 1x cable set for DC connection
- 1x system diagram
- 1x system configuration via VRM, system introduction approx. 30min
For further questions regarding the dimensioning or design of the solar system, we will be happy to advise you individually.
Contact us without obligation. +41 55 505 22 30
ESS-1P-Set-5kVA15S
Data sheet
- Battery voltage
- https://shop.autarking.ch/systemuberwachung/2618-energiezaehler-et340-3-phase-max-65ap-8719076039693.html
- Amperage
- 250A (Spitze 5 Sek. 375A)
- Nominal PV power 48V
- 5800W
- PV input voltage
- 250V
- Inverter power (25°) W
- 4000W
- Inverter power peak
- 9000W
- Transfer switch
- 32A
- Interface
- VE.Bus
- Interface
- Ethernet
- Interface
- Wifi
- Interface
- USB
- Interface
- VE.CAN & VE.Direct & Bluetooth
- Scope of delivery
- Batterie & BMU, Wechselrichter/Lader, Daten- & DC Kabel, DC Sicherung & Hauptschalter
- Weight
- ca. 200kg
- Capacity / Wh
- 15.3kWh
- Guarantee
- 4x Temperatur Eingänge oder via Bluetooth
- Temperature range
- Batterie & BMU, Wechselrichter/Lader, Daten- & DC Kabel, DC Sicherung & Hauptschalter
- Regenerative power supply capable (ESS) Switzerland ?
- JA - ENS / Anti Insel Schutz integriert
- Hint
- zur Überwachung via VRM Portal ist ein Internetanschluss via Wifi oder LAN notwendig
You might also like
-
- New
SolarEnergyStorageSet 1Phase - 5kVA, 15.4kWh, 5.8kWp
- 1 inverter/charger/solar combi with 5kVA / 5.5kVA peak & 5.8kWp solar controller
- 1 BYD LVL 15.4kWh storage battery
- 3-phase grid meter (phase compensation)
- DC cable and DC fuse, (AC integration must be carried out by an electrician)
- System diagram, configuration via VRM, support for installation