Argofet 100-2, 2 batteries 100A
ARG100201020
Charging current distributor 100A, 2 batteries
- System voltage 12/ 24V, charging current max. 100A
- Outputs: 2, voltage drop: 0.02 - 0.1V
- Compensation output, with starting excitation
Argo FET battery isolator
Similar to isolating diodes, FET isolators allow two or more batteries to be charged simultaneously by a generator or charger connection without connecting the batteries to each other. A discharge of the on-board battery does not lead to a simultaneous discharge of the starter battery. In contrast to isolating diodes, there is practically no voltage loss with FET isolators. The voltage drop is less than 0.02 volts at low currents and only 0.1 volts at higher currents. With ARGO FET battery isolation, no voltage increase is required. However, care should be taken to ensure short cable lengths and sufficient cross-sections.
Generator starting excitation
Some generator types require a DC voltage at the B+ pole for starting excitation. On the one hand, there is a direct cable connection between the battery and the alternator. On the other hand, however, the isolating diode prevents the current from flowing back so that the generator does not start. The new Argofet battery isolator has a special current-limited connection for starting excitation when the alternator is started.
ARG100201020
Data sheet
- System voltage
- 12 - 24V
- Amperage
- 100A
- Connections
- M8
- Number of outputs
- 2
- Dimension
- 65 x 120 x 200mm
- Weight
- 1.4kg
- Hint
- mit Anlauferregung
Charging current distributor 100A, 2 batteries
- System voltage 12/ 24V, charging current max. 100A
- Outputs: 2, voltage drop: 0.02 - 0.1V
- Compensation output, with starting excitation